Question: What SWR Is Too High?

How do I fix high SWR?

When you are experiencing a high SWR reading on one end of the frequency range, it is easy to adjust (lengthen or shorten) your antenna system to correct the problem..

Does coax length affect SWR?

“the length of the feedline will not change the swr it will change the apparent reading depending on what wave length you read the swr at. . just as adding a signifigant length of coax, the resultant loss will look like a lower swr.”

What does an SWR reading of 4 1 indicate?

What does an SWR reading of 4:1 indicate? Loss of -4 dB. Good impedance match. Gain of +4 dB. Impedance mismatch.

Is 1.5 SWR good?

SWR RANGE EXPLANATIONS. SWR 1.0-1.5: The ideal range! If your SWR is under 1.5, you’re in great shape. If you’re at 1.5 and really, really want to drop down to closer to 1 it’s likely possible to do with addition tuning, different equipment or a different mounting location.

Does a CB antenna need to be grounded?

Ground Your Antenna Mount If you’re using a standard CB antenna (i.e., anything except a no ground plane, or NGP, kit), you’ll need to make sure your antenna mount is solidly grounded to the vehicle’s chassis. A bad ground will result in an un-tunable antenna and sky-high SWR levels.

What causes high SWR?

One of the most common causes of high SWR readings is incorrectly connecting your SWR meter to your radio and antenna. When attached incorrectly, readings will be reported as being extremely high even if everything is installed perfectly.

Does SWR increase with power?

SWR really doesn’t increase with power. It’s always the same.

What affects SWR?

There are many things other than the antenna that can cause high SWR. SWR meter readings take into consideration the antenna, the coaxial cable, the mount, the mounting location, the vehicle and objects in the antennas near-field environment.

Why the SWR goes higher when I use an amplifier?

if the swr meter is connected between the output of the amp and the antenna this rule applies. using more power than necessary to obtain a set meter reading will result in higher swr readings.

How do you adjust the SWR on a CB radio?

Turn the radio to channel 1. Key the microphone (depress the button and hold it). Turn the knob on the SWR meter labeled “SET” or “ADJUST” until the needle reaches the setting position at the end of its range. While still keying the microphone, flip the switch on the SWR meter to the “REF” or “SWR” position.

Can SWR be too low?

An SWR too low over the whole band (1:1 for all 40 channels) can indicate a low efficiency antenna or lossy component. … If you have an antenna that’s say, three feet or less, and the SWR tunes great (less than 1.5) across all the channels than maybe your antennas feedline coax or the antenna coil is “lossy”.

How does high SWR damage a radio?

High SWR can reflect enough power back into the radio to create enough heat to cook the final RF transistor. It isn’t usually an immediate failure, it takes some time for that heat to build up and do damage.

What should your SWR be?

SWR Range Explanations: SWR 1.0-1.5: The ideal range! If your SWR is under 1.5, you’re in great shape. If you’re at 1.5 and really, really want to drop down to closer to 1 it’s likely possible to do with addition tuning, different equipment or a different mounting location.

What does a very high SWR reading mean?

What does a very high SWR reading mean? The transmitter is putting out more power than normal, showing that it is about to go bad. The antenna is the wrong length, or there may be an open or shorted connection somewhere in the feed line. There is a large amount of solar radiation, which means very poor radio conditions.

Does SWR affect reception?

Simplified answer: There is no relationship between SWR and receive performance. … SWR is a measure of the impedance mismatch between your antenna and transceiver. Whether transmitting or receiving, a higher SWR correlates with a less efficient coupling of energy between the transceiver and antenna.

Is a longer CB antenna better?

Choosing the Optimal CB Antenna Length Yes, taller/longer is better for range of distance when it comes to an antenna and the optimal antenna length is 1/4 wavelength. That translates to 102 inches (8.5 feet), too tall to be practical for most mobile applications.

How can I improve my CB reception?

There are several procedures for ensuring maximum output.TUNE THE RADIO. A CB radio is only as good as the coax and antenna connected to it. … USE CB-SPECIFIC ANTENNAS. … ESTABLISH A GROUND PLANE. … CHECK THE VSWR. … ELIMINATE RESISTANCE.